Main technical points of automatic winding machine
1. First of all, you must have a good understanding of the characteristics of the wire material, the number of turns, the appearance material and the winding speed.
1. Such as self-adhesive thread, enamelled cotton thread, etc., these coils need to be set to increase the number of coils, and because the outer skin is not smooth, it requires lower inertia.
2. For the thin wire, the winding speed should not be too slow, but it needs to climb slowly at the time of starting to avoid the excessively fast pneumatic speed pulling the wire.
3. The thicker wire should not be too fast, but the low speed torque must be sufficient.
Second, the shape of the object to be wound has a considerable relationship with the winding and winding distance of the automatic winding machine.
1. If the object to be wound is square, the winding speed should not be too fast, otherwise there will be roundness and unevenness in the middle.
2. The height of the object to be wrapped and the fully automatic winding machine should be appropriate. If it is too low, the wire will easily fall into the next layer, and if it is too high, there will be a jumper phenomenon.
3. The distance between the fully automatic winding machine and the object to be wound should not be too far, otherwise it will affect the accuracy of the winding.
4. The tightness of the fully automatic winding outlet is directly related to the appearance of the winding and winding.
3. Other matters:
1. Calibrating the width of the object to be wrapped and starting the winding point are the first choices.
2. When the pneumatic winding point is confirmed, you can start winding, or you can stop at both ends to test whether the set width is correct.
3. When the winding starts, whether it is beautiful or not, it can provide users with a lot of operable information.